Keysight Technologies InfiniiVision 3000T X Series - :SAVE:IMAGe:AREA

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1225
:SAVE:IMAGe:AREA
(see page 1276)
Query Syntax
:SAVE:IMAGe:AREA?
The :SAVE:IMAGe:AREA? query returns the selected image area.
When saving images, this query returns SCR (screen). When saving setups or
waveform data, this query returns GRAT (graticule) even though graticule images
are not saved.
Return Format
<area><NL>
<area> ::= {GRAT | SCR}
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:IMAGe[:STARt]" on page 673
• ":SAVE:IMAGe:FACTors" on page 674
• ":SAVE:IMAGe:FORMat" on page 675
• ":SAVE:IMAGe:INKSaver" on page 676
• ":SAVE:IMAGe:PALette" on page 677