Keysight Technologies InfiniiVision 3000T X Series - :SAVE:IMAGe:FACTors

674 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE:IMAGe:FACTors
(see page 1276)
Command Syntax
:SAVE:IMAGe:FACTors <factors>
<factors> ::= {{OFF | 0} | {ON | 1}}
The :SAVE:IMAGe:FACTors command controls whether the oscilloscope factors are
output along with the image.
Query Syntax
:SAVE:IMAGe:FACTors?
The :SAVE:IMAGe:FACTors? query returns a flag indicating whether oscilloscope
factors are output along with the image.
Return Format
<factors><NL>
<factors> ::= {0 | 1}
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:IMAGe[:STARt]" on page 673
• ":SAVE:IMAGe:FORMat" on page 675
• ":SAVE:IMAGe:INKSaver" on page 676
• ":SAVE:IMAGe:PALette" on page 677
NOTE
Factors are written to a separate file with the same path and base name but with the ".txt"
extension.