Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

:TRIGger Commands 33

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1015

:TRIGger:LEVel:LOW

(see page 1276)

Command Syntax

:TRIGger:LEVel:LOW <level>, <source>

<level> ::= 0.75 x full-scale voltage from center screen in NR3 format

for internal triggers

<source> ::= CHANnel<n>

<n> ::= 1 to (# analog channels) in NR1 format

The :TRIGger:LEVel:LOW command sets the low trigger voltage level voltage for

the specified source.

High and low trigger levels are used with runt triggers and rise/fall time

(transition) triggers.

Query Syntax

:TRIGger:LEVel:LOW? <source>

The :TRIGger:LEVel:LOW? query returns the low trigger voltage level for the

specified source.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 1007

• ":TRIGger:LEVel:HIGH" on page 1014

• ":TRIGger:RUNT Commands" on page 1056

• ":TRIGger:TRANsition Commands" on page 1067

• ":TRIGger[:EDGE]:SOURce" on page 1036

Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:LEVel:LOW