To Next Page

To Previous Page

822 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

29 :SBUS<n> Commands

:SBUS<n>:SENT:DISPlay

(see page 1276)

Command Syntax

:SBUS<n>:SENT:DISPlay <base>

<base> ::= {HEX | DECimal | SYMBolic}

The :SBUS<n>:SENT:DISPlay command specifies the number base used by the

decoder. The chosen base is used for the data nibbles in Raw decode format, the

defined Signals in the other formats, and for the data field of the Serial Messages.

This selection is used for both the Lister and the decode line displays.

When SYMBolic is selected, Fast Channel Signals display a calculated physical

value based on the specified multiplier and offset:

• PhysicalValue = (Multiplier * SignalValueAsUnsignedInteger) + Offset

When SYMBolic is selected, the CRC and Slow Channel information is displayed in

hex.

Query Syntax

:SBUS<n>:SENT:DISPlay?

The :SBUS<n>:SENT:DISPlay? query returns the SENT decode number base

setting.

Return Format

<base> ::= {HEX | DEC | SYMB}

See Also • ":SBUS<n>:SENT:CLOCk" on page 820

• ":SBUS<n>:SENT:CRC" on page 821

• ":SBUS<n>:SENT:FORMat" on page 824

• ":SBUS<n>:SENT:IDLE" on page 826

• ":SBUS<n>:SENT:LENGth" on page 827

• ":SBUS<n>:SENT:PPULse" on page 828

• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 829

• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 830

• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 832

• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 833

• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 834

• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 836

• ":SBUS<n>:SENT:SOURce" on page 838

• ":SBUS<n>:SENT:TOLerance" on page 840

• ":SBUS<n>:SENT:TRIGger" on page 841

• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 843

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: