:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 615
:POWer:ONOFf:EXIT
(see page 1276)
Command Syntax
:POWer:ONOFf:EXIT
The :POWer:ONOFf:EXIT command exits (stops) the turn on time/turn off time
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:ONOFf:APPLy" on page 614
• ":POWer:ONOFf:NEXT" on page 616
• ":POWer:ONOFf:TEST" on page 617
To Next Page
Loading...
