Keysight Technologies InfiniiVision 3000T X Series - :FFT:CLEar

:FFT Commands 17
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 349
:FFT:CLEar
(see page 1276)
Command Syntax
:FFT:CLEar
When the FFT display mode is AVERage, MAXHold, or MINHold, the :FFT:CLEar
command clears the number of evaluated waveforms.
See Also • ":FFT:AVERage:COUNt" on page 347
• ":FFT:CENTer" on page 348
• ":FFT:DISPlay" on page 350
• ":FFT:DMODe" on page 351
• ":FFT:OFFSet" on page 353
• ":FFT:RANGe" on page 354
• ":FFT:REFerence" on page 355
• ":FFT:SCALe" on page 356
• ":FFT:SOURce1" on page 357
• ":FFT:SPAN" on page 358
• ":FFT:STARt" on page 359
• ":FFT:STOP" on page 360
• ":FFT:VTYPe" on page 361
• ":FFT:WINDow" on page 362