Keysight Technologies InfiniiVision 3000T X Series - :HARDcopy:DESTination

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1197
:HARDcopy:DESTination
(see page 1276)
Command Syntax
:HARDcopy:DESTination <destination>
<destination> ::= {CENTronics | FLOPpy}
The :HARDcopy:DESTination command sets the hardcopy destination.
Query Syntax
:HARDcopy:DESTination?
The :HARDcopy:DESTination? query returns the selected hardcopy destination.
Return Format
<destination><NL>
<destination> ::= {CENT | FLOP}
See Also • "Introduction to :HARDcopy Commands" on page 404
NOTE
The :HARDcopy:DESTination command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :HARDcopy:FILename command (see page 1198) instead.