Keysight Technologies InfiniiVision 3000T X Series User Manual

404 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
19 :HARDcopy Commands
Introduction to
:HARDcopy
Commands
The HARDcopy subsystem provides commands to set and query the selection of
hardcopy device and formatting options such as inclusion of instrument settings
(FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this case, the
query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
:HARDcopy:NETWork:PAS
Sword <password> (see
page 414)
n/a <password> ::= quoted ASCII
string
:HARDcopy:NETWork:SLO
T <slot> (see
page 415)
:HARDcopy:NETWork:SLO
T? (see page 415)
<slot> ::= {NET0 | NET1}
:HARDcopy:NETWork:USE
Rname <username> (see
page 416)
:HARDcopy:NETWork:USE
Rname? (see page 416)
<username> ::= quoted ASCII
string
:HARDcopy:PALette
<palette> (see
page 417)
:HARDcopy:PALette?
(see page 417)
<palette> ::= {COLor | GRAYscale
| NONE}
n/a :HARDcopy:PRINter:LIS
T? (see page 418)
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
:HARDcopy:STARt (see
page 419)
n/a n/a
Table 97 :HARDcopy Commands Summary (continued)
Command Query Options and Query Returns

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English