To Next Page

To Previous Page

862 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

29 :SBUS<n> Commands

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA

(see page 1276)

Command Syntax

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA <string>

<string> ::= "nn...n" where n ::= {0 |1|X|$}

<string ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X | $}

The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA command defines the SPI data

pattern resource according to the string parameter. This pattern, along with the

data width, control the data pattern searched for in the data stream.

If the string parameter starts with "0x", it is a hexadecimal string made up of

hexadecimal and X (don't care) characters; otherwise, it is a binary string made up

of 0, 1, and X (don't care) characters.

Query Syntax

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA?

The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA? query returns the current

settings of the specified SPI data pattern resource in the binary string format.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 1007

• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh" on page 863

• ":SBUS<n>:SPI:SOURce:MOSI" on page 859

NOTE

The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh should be set before

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA.

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: