Keysight Technologies InfiniiVision 3000T X Series User Manual

:WGEN<w> Commands 35
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1159
:WGEN<w>:PERiod
(see page 1276)
Command Syntax
:WGEN<w>:PERiod <period>
<w> ::= 1 or 2 in NR1 format
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN<w>:PERiod command
specifies the period of the waveform.
You can also specify the period indirectly using the :WGEN<w>:FREQuency
command.
Query Syntax
:WGEN<w>:PERiod?
The :WGEN<w>:PERiod? query returns the currently set waveform generator
period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also • "Introduction to :WGEN<w> Commands" on page 1128
• ":WGEN<w>:FUNCtion" on page 1137
• ":WGEN<w>:FREQuency" on page 1136

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English