Keysight Technologies InfiniiVision 3000T X Series - :SINGle

226 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
:SINGle
(see page 1276)
Command Syntax
:SINGle
The :SINGle command causes the instrument to acquire a single trigger of data.
This is the same as pressing the Single key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 194
• ":RUN" on page 224
• ":STOP" on page 228