To Next Page

To Previous Page

:RECall Commands 27

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 659

:RECall:ARBitrary[:STARt]

(see page 1276)

Command Syntax

:RECall:ARBitrary:[STARt] [<file_spec>][, <column>][, <wavegen_id>]

<file_spec> ::= {<internal_loc> | <file_name>}

<column> ::= Column in CSV file to load. Column number starts from 1.

<wavegen_id> ::= WGEN1 - specifies which wavegen

<internal_loc> ::= 0-3; an integer in NR1 format

<file_name> ::= quoted ASCII string

The :RECall:ARBitrary:[STARt] command recalls an arbitrary waveform.

For internal locations, the <column> parameter is ignored.

For external (USB storage device) files, the column parameter is optional. If no

<column> parameter is entered, and it is a 2-column file, the 2nd column

(assumed to be voltage) is automatically be selected. If the <column> parameter is

entered, and that column does not exist in the file, the operation fails.

When recalling arbitrary waveforms (from an external USB storage device) that

were not saved from the oscilloscope, be aware that the oscilloscope uses a

maximum of 8192 points for an arbitrary waveform. For more efficient recalls,

make sure your arbitrary waveforms are 8192 points or less.

The <wavegen_id> parameter specifies which waveform generator to recall the

arbitrary waveform into.

See Also • "Introduction to :RECall Commands" on page 658

• ":RECall:FILename" on page 661

• ":RECall:PWD" on page 663

• ":SAVE:ARBitrary[:STARt]" on page 671

NOTE

If a file extension is provided as part of a specified <file_name>, it must be ".csv".

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: