Keysight Technologies InfiniiVision 3000T X Series User Manual

:MTESt Commands 24
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 555
:MTESt:AMASk:CREate
(see page 1276)
Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask around the
current selected channel, using the tolerance parameters defined by the
:MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and :MTESt:AMASk:UNITs
commands. The mask only encompasses the portion of the waveform visible on
the display, so you must ensure that the waveform is acquired and displayed
consistently to obtain repeatable results.
The :MTESt:SOURce command selects the channel and should be set before using
this command.
See Also • "Introduction to :MTESt Commands" on page 551
• ":MTESt:AMASk:XDELta" on page 558
• ":MTESt:AMASk:YDELta" on page 559
• ":MTESt:AMASk:UNITs" on page 557
• ":MTESt:AMASk:SOURce" on page 556
• ":MTESt:SOURce" on page 581
Example Code • "Example Code" on page 551

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English