To Next Page

To Previous Page

Root (:) Commands 6

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 199

:AUToscale:AMODE

(see page 1276)

Command Syntax

:AUToscale:AMODE <value>

<value> ::= {NORMal | CURRent}

The :AUTOscale:AMODE command specifies the acquisition mode that is set by

subsequent :AUToscales.

• When NORMal is selected, an :AUToscale command sets the NORMal

acquisition type and the RTIMe (real-time) acquisition mode.

• When CURRent is selected, the current acquisition type and mode are kept on

subsequent :AUToscales.

Use the :ACQuire:TYPE and :ACQuire:MODE commands to set the acquisition type

and mode.

Query Syntax

:AUToscale:AMODE?

The :AUToscale:AMODE? query returns the autoscale acquire mode setting.

Return Format

<value> ::= {NORM | CURR}

See Also • "Introduction to Root (:) Commands" on page 194

• ":AUToscale" on page 197

• ":AUToscale:CHANnels" on page 200

• ":ACQuire:TYPE" on page 243

• ":ACQuire:MODE" on page 235

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: