Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:CYCLes:HARMonics

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 625
:POWer:SIGNals:CYCLes:HARMonics
(see page 1276)
Command Syntax
:POWer:SIGNals:CYCLes:HARMonics <count>
<count> ::= integer in NR1 format
Legal values are 1 to 100.
The :POWer:SIGNals:CYCLes:HARMonics command specifies the number of cycles
to include in the current harmonics analysis.
Query Syntax
:POWer:SIGNals:CYCLes:HARMonics?
The :POWer:SIGNals:CYCLes:HARMonics query returns the number of cycles
currently set.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also • ":POWer:HARMonics:DISPlay" on page 600
• ":POWer:HARMonics:APPLy" on page 598
• ":POWer:SIGNals:AUTosetup" on page 624
• ":POWer:SIGNals:IEXPected" on page 633
• ":POWer:SIGNals:OVERshoot" on page 634
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 641
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 642