Keysight Technologies InfiniiVision 3000T X Series - :WGEN<w>:ARBitrary:INTerpolate

1134 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:ARBitrary:INTerpolate
(see page 1276)
Command Syntax
:WGEN<w>:ARBitrary:INTerpolate {{0 | OFF} | {1 | ON}}
<w> ::= 1 or 2 in NR1 format
The :WGEN<w>:ARBitrary:INTerpolate command enables or disables the
Interpolation control.
Interpolation specifies how lines are drawn between arbitrary waveform points:
• When ON, lines are drawn between points in the arbitrary waveform. Voltage
levels change linearly between one point and the next.
• When OFF, all line segments in the arbitrary waveform are horizontal. The
voltage level of one point remains until the next point.
Query Syntax
:WGEN<w>:ARBitrary:INTerpolate?
The :WGEN<w>:ARBitrary:INTerpolate query returns the current interpolation
setting.
Return Format
{0 | 1}
See Also • ":WGEN<w>:ARBitrary:DATA" on page 1130
• ":WGEN<w>:ARBitrary:DATA:DAC" on page 1133
• ":SAVE:ARBitrary[:STARt]" on page 671
• ":RECall:ARBitrary[:STARt]" on page 659