1130 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:ARBitrary:DATA
(see page 1276)
Command Syntax
:WGEN<w>:ARBitrary:DATA {<binary> | <value>, <value> ...}
<w> ::= 1 or 2 in NR1 format
<binary> ::= floating point values between -1.0 to +1.0
in IEEE 488.2 binary block format
<value> ::= floating point values between -1.0 to +1.0
in comma-separated format
The :WGEN<w>:ARBitrary:DATA command downloads an arbitrary waveform in
floating-point values format.
See Also • ":WGEN<w>:ARBitrary:DATA:DAC" on page 1133
• ":SAVE:ARBitrary[:STARt]" on page 671
• ":RECall:ARBitrary[:STARt]" on page 659
To Next Page
Loading...
