To Next Page

To Previous Page

Root (:) Commands 6

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 203

:DIGitize

(see page 1276)

Command Syntax

:DIGitize [<source>[,..,<source>]]

<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | SBUS{1 | 2}}

for the DSO models

<source> ::= {CHANnel<n> | DIGital<d> | POD{1 | 2}

| BUS{1 | 2} | FUNCtion<m> | MATH<m> | SBUS{1 | 2}}

for the MSO models

<n> ::= 1 to (# analog channels) in NR1 format

<d> ::= 0 to (# digital channels - 1) in NR1 format

<m> ::= 1 to (# math functions) in NR1 format

The <source> parameter may be repeated up to 5 times.

The :DIGitize command is a specialized RUN command. It causes the instrument

to acquire waveforms according to the settings of the :ACQuire commands

subsystem. When the acquisition is complete, the instrument is stopped.

If no argument is given, :DIGitize acquires the channels currently displayed. If no

channels are displayed, all channels are acquired.

See Also • "Introduction to Root (:) Commands" on page 194

• ":RUN" on page 224

• ":SINGle" on page 226

• ":STOP" on page 228

• ":TIMebase:MODE" on page 997

• Chapter 7, “:ACQuire Commands,” starting on page 231

• Chapter 34, “:WAVeform Commands,” starting on page 1089

NOTE

The :DIGitize command is only executed when the :TIMebase:MODE is MAIN or WINDow.

NOTE

To halt a :DIGitize in progress, use the device clear command.

NOTE

MATH<m> is an alias for FUNCtion<m>.

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: