Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

1202 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

37 Obsolete and Discontinued Commands

:MEASure:LOWer

(see page 1276)

Command Syntax

:MEASure:LOWer <voltage>

The :MEASure:LOWer command sets the lower measurement threshold value. This

value and the UPPer value represent absolute values when the thresholds are

ABSolute and percentage when the thresholds are PERCent as defined by the

:MEASure:DEFine THResholds command.

Query Syntax

:MEASure:LOWer?

The :MEASure:LOWer? query returns the current lower threshold level.

Return Format

<voltage> ::= the user-defined lower threshold in volts in NR3 format

See Also • "Introduction to :MEASure Commands" on page 458

• ":MEASure:THResholds" on page 1205

• ":MEASure:UPPer" on page 1211

NOTE

The :MEASure:LOWer command is obsolete and is provided for backward compatibility to

previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see page 467)

instead.

Keysight Technologies InfiniiVision 3000T X Series - :MEASure:LOWer