To Next Page

To Previous Page

1088 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

33 :TRIGger Commands

:TRIGger:ZONE<n>:STATe

(see page 1276)

Command Syntax

:TRIGger:ZONE<n>:STATe <on_off>

<n> ::= {1 | 2}

<on_off> ::= {{0 | OFF} | {1 | ON}}

<n> ::= 1-2 in NR1 format

The :TRIGger:ZONE<n>:STATe command sets the state for Zone 1 or Zone 2.

• When a zone's state is on, and the Zone Trigger feature is on (see

":TRIGger:ZONE:STATe" on page 1084), that zone is actively being used to

qualify the trigger if it is not invalid or off-screen (see

":TRIGger:ZONE<n>:VALidity" on page 1087).

• When the Zone Trigger feature is off, no zones are being used to qualify the

trigger, regardless of their individual states.

Note that :TRIGger:ZONE:STATe mimics the behavior of the [Zone] key on the front

panel, and :TRIGger:ZONE<n>:STATe mimics the behavior of the Zone 1 On and

Zone 2 On softkeys. At least one zone's state must be on for the Zone Trigger

feature (:TRIGger:ZONE:STATe) to be on. When the states of both individual zones

are turned off, Zone Trigger is automatically turned off. In this case, when Zone

Trigger is turned back on Zone 1 is forced to on. Otherwise, if at least one zone

was on when Zone Trigger was turned off, the same configuration of individual

zone on/off states will be restored when Zone Trigger is turned back on.

Query Syntax

:TRIGger:ZONE<n>:STATe?

The :TRIGger:ZONE<n>:STATe? query returns the state of Zone 1 or Zone 2.

Return Format

<on_off><NL>

<on_off> ::= {0 | 1}

See Also • ":TRIGger:ZONE:STATe" on page 1084

• ":TRIGger:ZONE<n>:VALidity" on page 1087

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: