Keysight Technologies InfiniiVision 3000T X Series User Manual

664 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
27 :RECall Commands
:RECall:SETup[:STARt]
(see page 1276)
Command Syntax
:RECall:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:SETup[:STARt] command recalls an oscilloscope setup.
See Also • "Introduction to :RECall Commands" on page 658
• ":RECall:FILename" on page 661
• ":RECall:PWD" on page 663
• ":SAVE[:SETup[:STARt]]" on page 689
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".scp".

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English