To Next Page

To Previous Page

:TIMebase Commands 32

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 997

:TIMebase:MODE

(see page 1276)

Command Syntax

:TIMebase:MODE <value>

<value> ::= {MAIN | WINDow | XY | ROLL}

The :TIMebase:MODE command sets the current time base. There are four time

base modes:

• MAIN — The normal time base mode is the main time base. It is the default time

base mode after the *RST (Reset) command.

• WINDow — In the WINDow (zoomed or delayed) time base mode,

measurements are made in the zoomed time base if possible; otherwise, the

measurements are made in the main time base.

• XY — In the XY mode, the :TIMebase:RANGe, :TIMebase:POSition, and

:TIMebase:REFerence commands are not available. No measurements are

available in this mode.

• ROLL — In the ROLL mode, data moves continuously across the display from

left to right. The oscilloscope runs continuously and is untriggered. The

:TIMebase:REFerence selection changes to RIGHt.

Query Syntax

:TIMebase:MODE?

The :TIMebase:MODE query returns the current time base mode.

Return Format

<value> ::= {MAIN | WIND | XY | ROLL}

See Also • "Introduction to :TIMebase Commands" on page 996

• "*RST (Reset)" on page 180

• ":TIMebase:RANGe" on page 999

• ":TIMebase:POSition" on page 998

• ":TIMebase:REFerence" on page 1000

Example Code

' TIMEBASE_MODE - (not executed in this example)

' Set the time base mode to MAIN, DELAYED, XY, or ROLL.

' Set time base mode to main.

myScope.WriteString ":TIMEBASE:MODE MAIN"

See complete example programs at: Chapter 42, “Programming Examples,”

starting on page 1285

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: