Keysight Technologies InfiniiVision 3000T X Series - :POWer:SLEW:SOURce

644 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:SLEW:SOURce
(see page 1276)
Command Syntax
:POWer:SLEW:SOURce <source>
<source> ::= {V | I}
The :POWer:SLEW:SOURce command selects either the voltage source or the
current source as the source for the slew rate analysis.
Query Syntax
:POWer:SLEW:SOURce?
The :POWer:SLEW:SOURce query returns the selected source for the slew rate
analysis.
Return Format
<source><NL>
<source> ::= {V | I}
See Also • ":POWer:SLEW:APPLy" on page 643