Keysight Technologies InfiniiVision 3000T X Series - :WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry

:WGEN<w> Commands 35
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1151
:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry
(see page 1276)
Command Syntax
:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry <percent>
<w> ::= 1 in NR1 format
<percent> ::= symmetry percentage from 0% to 100% in NR1 format
The :WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry command specifies the
amount of time per cycle that the ramp waveform is rising. The ramp modulating
waveform shape is specified with the :WGEN<w>:MODulation:FUNCtion
command.
Query Syntax
:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry?
The :WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry? query returns ramp
symmetry percentage setting.
Return Format
<percent><NL>
<percent> ::= symmetry percentage from 0% to 100% in NR1 format
See Also • ":WGEN<w>:MODulation:AM:DEPTh" on page 1144
• ":WGEN<w>:MODulation:AM:FREQuency" on page 1145
• ":WGEN<w>:MODulation:FM:DEViation" on page 1146
• ":WGEN<w>:MODulation:FM:FREQuency" on page 1147
• ":WGEN<w>:MODulation:FSKey:FREQuency" on page 1148
• ":WGEN<w>:MODulation:FSKey:RATE" on page 1149
• ":WGEN<w>:MODulation:FUNCtion" on page 1150
• ":WGEN<w>:MODulation:STATe" on page 1153
• ":WGEN<w>:MODulation:TYPE" on page 1154