Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

310 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

13 :DIGital<d> Commands

:DIGital<d>:LABel

(see page 1276)

Command Syntax

:DIGital<d>:LABel <string>

<d> ::= 0 to (# digital channels - 1) in NR1 format

<string> ::= any series of 10 or less characters as quoted ASCII string.

The :DIGital<d>:LABel command sets the channel label to the string that follows.

Setting a label for a channel also adds the name to the label list in non-volatile

memory (replacing the oldest label in the list).

Query Syntax

:DIGital<d>:LABel?

The :DIGital<d>:LABel? query returns the name of the specified channel.

Return Format

<label string> ::= any series of 10 or less characters as a quoted

ASCII string.

See Also • "Introduction to :DIGital<d> Commands" on page 308

• ":CHANnel<n>:LABel" on page 273

• ":DISPlay:LABList" on page 328

• ":BUS<n>:LABel" on page 252

NOTE

This command is only valid for the MSO models.

NOTE

Label strings are 10 characters or less, and may contain any commonly used ASCII characters.

Labels with more than 10 characters are truncated to 10 characters.

Keysight Technologies InfiniiVision 3000T X Series - :DIGital<d>:LABel