Keysight Technologies InfiniiVision 3000T X Series - :DEMO:FUNCtion:PHASe:PHASe

304 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
12 :DEMO Commands
:DEMO:FUNCtion:PHASe:PHASe
(see page 1276)
Command Syntax
:DEMO:FUNCtion:PHASe:PHASe <angle>
<angle> ::= angle in degrees from 0 to 360 in NR3 format
For the phase shifted sine demo signals, the :DEMO:FUNCtion:PHASe:PHASe
command specifies the phase shift in the second sine waveform.
Query Syntax
:DEMO:FUNCtion:PHASe:PHASe?
The :DEMO:FUNCtion:PHASe:PHASe? query returns the currently set phase shift.
Return Format
<angle><NL>
<angle> ::= angle in degrees from 0 to 360 in NR3 format
See Also • "Introduction to :DEMO Commands" on page 299
• ":DEMO:FUNCtion" on page 300