Common (*) Commands 5
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 183
*SAV (Save)
(see page 1276)
Command Syntax
*SAV <value>
<value> ::= {0|1|2|3|4|5|6|7|8|9}
The *SAV command stores the current state of the instrument in a save register.
The data parameter specifies the register where the data will be saved.
See Also • "Introduction to Common (*) Commands" on page 168
• "*RCL (Recall)" on page 179
To Next Page
Loading...
