182 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
5 Common (*) Commands
See Also • "Introduction to Common (*) Commands" on page 168
• ":SYSTem:PRESet" on page 987
Example Code
' RESET - This command puts the oscilloscope into a known state.
' This statement is very important for programs to work as expected.
' Most of the following initialization commands are initialized by
' *RST. It is not necessary to reinitialize them unless the default
' setting is not suitable for your application.
myScope.WriteString "*RST" ' Reset the oscilloscope to the defaults.
See complete example programs at: Chapter 42, “Programming Examples,”
starting on page 1285
HF Reject and noise reject Off
Holdoff 40 ns
External probe attenuation 10:1
External Units Volts
External Impedance 1 M Ohm (cannot be changed)
Trigger Menu
To Next Page
Loading...
