Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

1212 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

37 Obsolete and Discontinued Commands

:MEASure:VDELta

(see page 1276)

Query Syntax

:MEASure:VDELta?

The :MEASure:VDELta? query returns the voltage difference between vertical

marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No measurement is made

when the :MEASure:VDELta? query is received by the oscilloscope. The delta value

that is returned is the current value. This is the same value as the front-panel

cursors delta Y value.

VDELta = value at marker 2 - value at marker 1

Return Format

<value> ::= delta V value in NR1 format

See Also • "Introduction to :MARKer Commands" on page 426

• "Introduction to :MEASure Commands" on page 458

• ":MARKer:Y1Position" on page 437

• ":MARKer:Y2Position" on page 438

• ":MARKer:YDELta" on page 439

• ":MEASure:TDELta" on page 1204

• ":MEASure:TSTArt" on page 1208

NOTE

The :MEASure:VDELta command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:YDELta command (see page 439) instead.

Keysight Technologies InfiniiVision 3000T X Series - :MEASure:VDELta