Keysight Technologies InfiniiVision 3000T X Series User Manual

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1213
:MEASure:VSTArt
(see page 1276)
Command Syntax
:MEASure:VSTArt <vstart_argument>
<vstart_argument> ::= value for vertical marker 1
The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to the
specified value corresponding to the selected source. The source can be selected
by the MARKer:X1Y1source command.
Query Syntax
:MEASure:VSTArt?
The :MEASure:VSTArt? query returns the current value of the Y1 cursor.
Return Format
<value><NL>
<value> ::= voltage at voltage marker 1 in NR3 format
See Also • "Introduction to :MARKer Commands" on page 426
• "Introduction to :MEASure Commands" on page 458
• ":MARKer:Y1Position" on page 437
• ":MARKer:Y2Position" on page 438
• ":MARKer:YDELta" on page 439
• ":MARKer:X1Y1source" on page 431
• ":MEASure:SOURce" on page 499
• ":MEASure:TDELta" on page 1204
• ":MEASure:TSTArt" on page 1208
NOTE
The short form of this command, VSTA, does not follow the defined Long Form to Short Form
Truncation Rules (see page 1278). The normal short form, VST, would be the same for both
VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.
NOTE
The :MEASure:VSTArt command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:Y1Position command (see page 437) instead.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English