Keysight Technologies InfiniiVision 3000T X Series - :HARDcopy:FACTors

:HARDcopy Commands 19
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 407
:HARDcopy:FACTors
(see page 1276)
Command Syntax
:HARDcopy:FACTors <factors>
<factors> ::= {{OFF | 0} | {ON | 1}}
The HARDcopy:FACTors command controls whether the scale factors are output
on the hardcopy dump.
Query Syntax
:HARDcopy:FACTors?
The :HARDcopy:FACTors? query returns a flag indicating whether oscilloscope
instrument settings are output on the hardcopy.
Return Format
<factors><NL>
<factors> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 404
• ":HARDcopy:STARt" on page 419
• ":HARDcopy:FFEed" on page 408
• ":HARDcopy:INKSaver" on page 409
• ":HARDcopy:LAYout" on page 410
• ":HARDcopy:PALette" on page 417