Keysight Technologies InfiniiVision 3000T X Series User Manual

Setting Up 2
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 43
Step 2. Connect and set up the oscilloscope
The 3000T X-Series oscilloscope has two different interfaces you can use for
programming:
• USB (device port).
• LAN. To configure the LAN interface, press the [Utility] key on the front panel,
then press the I/O softkey, then press the Configure softkey.
These interfaces are always active.
Using the USB (Device) Interface
1 Connect a USB cable from the controller PC's USB port to the "USB DEVICE"
port on the back of the oscilloscope.
This is a USB 2.0 high-speed port.
Using the LAN Interface
1 If the controller PC is not already connected to the local area network (LAN), do
that first.
2 Contact your network administrator about adding the oscilloscope to the
network.
Find out if automatic configuration via DHCP or AutoIP can be used. Also, find
out whether your network supports Dynamic DNS or Multicast DNS.
Figure 1 Control Connectors on Rear Panel
USB Device Port
LAN/VGA
Option Module
GPIB
Option Module

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English