Keysight Technologies InfiniiVision 3000T X Series - :CALibrate:PROTected

260 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
9 :CALibrate Commands
:CALibrate:PROTected
(see page 1276)
Query Syntax
:CALibrate:PROTected?
The :CALibrate:PROTected? query returns the rear-panel calibration protect (CAL
PROTECT) button state. The value PROTected indicates calibration is disabled,
and UNPRotected indicates calibration is enabled.
Return Format
<switch><NL>
<switch> ::= {PROTected | UNPRotected}
See Also • "Introduction to :CALibrate Commands" on page 256