Keysight Technologies InfiniiVision 3000T X Series - :POWer Commands

589
Keysight InfiniiVision 3000T X-Series Oscilloscopes
Programmer's Guide
26 :POWer Commands
These :POWer commands are available when the DSOX3PWR power
measurements and analysis application is licensed and enabled.
Table 104 :POWer Commands Summary
Command Query Options and Query Returns
:POWer:DESKew (see
page 594)
n/a n/a
:POWer:EFFiciency:APP
Ly (see page 595)
n/a n/a
:POWer:EFFiciency:TYP
E <type> (see
page 596)
:POWer:EFFiciency:TYP
E? (see page 596)
<type> ::= {DCDC | DCAC | ACDC |
ACAC}
:POWer:ENABle {{0 |
OFF} | {1 | ON}} (see
page 597)
:POWer:ENABle? (see
page 597)
{0 | 1}
:POWer:HARMonics:APPL
y (see page 598)
n/a n/a
n/a :POWer:HARMonics:DATA
? (see page 599)
<binary_block> ::=
comma-separated data with
newlines at the end of each row
:POWer:HARMonics:DISP
lay <display> (see
page 600)
:POWer:HARMonics:DISP
lay? (see page 600)
<display> ::= {TABLe | BAR | OFF}
n/a :POWer:HARMonics:FAIL
count? (see page 601)
<count> ::= integer in NR1 format
:POWer:HARMonics:LINE
<frequency> (see
page 602)
:POWer:HARMonics:LINE
? (see page 602)
<frequency> ::= {F50 | F60 |
F400}
n/a :POWer:HARMonics:POWe
rfactor? (see
page 603)
<value> ::= Class C power factor
in NR3 format