Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:FLEXray:COUNt:RESet

754 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:FLEXray:COUNt:RESet
(see page 1276)
Command Syntax
:SBUS<n>:FLEXray:COUNt:RESet
Resets the FlexRay frame counters.
Errors • "-241, Hardware missing" on page 1235
See Also • ":SBUS<n>:FLEXray:COUNt:NULL" on page 753
• ":SBUS<n>:FLEXray:COUNt:TOTal" on page 756
• ":SBUS<n>:FLEXray:COUNt:SYNC" on page 755
• "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:FLEXray Commands" on page 748