:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 611
:POWer:MODulation:APPLy
(see page 1276)
Command Syntax
:POWer:MODulation:APPLy
The :POWer:MODulation:APPLy command applies the selected modulation
analysis type (:POWer:MODulation:TYPE).
The Modulation analysis measures the control pulse signal to a switching device
(MOSFET) and observes the trending of the pulse width, duty cycle, period,
frequency, etc. of the control pulse signal.
See Also • ":POWer:MODulation:SOURce" on page 612
• ":POWer:MODulation:TYPE" on page 613
• ":MEASure:VAVerage" on page 512
• ":MEASure:VRMS" on page 518
• ":MEASure:VRATio" on page 517
• ":MEASure:PERiod" on page 488
• ":MEASure:FREQuency" on page 480
• ":MEASure:PWIDth" on page 492
• ":MEASure:NWIDth" on page 484
• ":MEASure:DUTYcycle" on page 478
• ":MEASure:RISetime" on page 496
• ":MEASure:FALLtime" on page 479
To Next Page
Loading...
