To Next Page

To Previous Page

:MEASure Commands 22

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 473

:MEASure:DUAL:VAMPlitude

(see page 1276)

Overview This measurement is available with the N2820A high sensitivity current probe

when both the Primary and Secondary probe cables are used. This measurement

joins the Zoom In waveform data below the probe's clamp level with Zoom Out

waveform data above the probe's clamp level to create the waveform on which the

measurement is made.

Command Syntax

:MEASure:DUAL:VAMPlitude [<source1>][,<source2>]

<source1>,<source2> ::= CHANnel<n> with N2820A probe connected

<n> ::= 1 to (# analog channels) in NR1 format

The :MEASure:DUAL:VAMPlitude command installs a screen measurement and

starts a vertical amplitude measurement.

If the optional source parameter(s) are specified, the currently specified source(s)

are modified.

Query Syntax

:MEASure:DUAL:VAMPlitude? [<source1>][,<source2>]

The :MEASure:DUAL:VAMPlitude? query measures and returns the vertical

amplitude of the waveform. To determine the amplitude, the instrument measures

Vtop and Vbase, then calculates the amplitude as follows:

vertical amplitude = Vtop - Vbase

Return Format

<value> ::= the amplitude of the selected waveform in NR3 format

See Also • ":MEASure:DUAL:CHARge" on page 472

• ":MEASure:DUAL:VAVerage" on page 474

• ":MEASure:DUAL:VBASe" on page 475

• ":MEASure:DUAL:VPP" on page 476

• ":MEASure:DUAL:VRMS" on page 477

• "Introduction to :MEASure Commands" on page 458

• ":MEASure:SOURce" on page 499

• ":MEASure:VTOP" on page 520

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: