Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:FLEXray:TRIGger:EVENt:AUToset

760 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
(see page 1276)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
The :SBUS<n>:FLEXray:TRIGger:EVENt:AUToset command automatically
configures oscilloscope settings (as shown on the display) for the selected event
trigger.
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 762
• ":SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID" on page 761
• ":SBUS<n>:FLEXray:TRIGger" on page 758
• ":SBUS<n>:FLEXray:BAUDrate" on page 751
• ":TRIGger[:EDGE]:LEVel" on page 1033
• ":SBUS<n>:FLEXray:SOURce" on page 757