Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:SOURce:CURRent<i>

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 641
:POWer:SIGNals:SOURce:CURRent<i>
(see page 1276)
Command Syntax
:POWer:SIGNals:SOURce:CURRent<i> <source>
<i> ::= 1, 2 in NR1 format
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:SIGNals:SOURce:CURRent<i> command specifies the first, and
perhaps second, current source channel to be used in the power analysis.
Query Syntax
:POWer:SIGNals:SOURce:CURRent<i>?
The :POWer:SIGNals:SOURce:CURRent<i> query returns the current source
channel setting.
Return Format
<source><NL>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
See Also • ":POWer:SIGNals:AUTosetup" on page 624
• ":POWer:SIGNals:CYCLes:HARMonics" on page 625
• ":POWer:SIGNals:CYCLes:QUALity" on page 626
• ":POWer:SIGNals:DURation:EFFiciency" on page 627
• ":POWer:SIGNals:DURation:MODulation" on page 628
• ":POWer:SIGNals:DURation:ONOFf:OFF" on page 629
• ":POWer:SIGNals:DURation:ONOFf:ON" on page 630
• ":POWer:SIGNals:DURation:RIPPle" on page 631
• ":POWer:SIGNals:DURation:TRANsient" on page 632
• ":POWer:SIGNals:IEXPected" on page 633
• ":POWer:SIGNals:OVERshoot" on page 634
• ":POWer:SIGNals:VMAXimum:INRush" on page 635
• ":POWer:SIGNals:VMAXimum:ONOFf:OFF" on page 636
• ":POWer:SIGNals:VMAXimum:ONOFf:ON" on page 637
• ":POWer:SIGNals:VSTeady:ONOFf:OFF" on page 638
• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 639
• ":POWer:SIGNals:VSTeady:TRANsient" on page 640
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 642