Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:UART:TRIGger:TYPE

886 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:UART:TRIGger:TYPE
(see page 1276)
Command Syntax
:SBUS<n>:UART:TRIGger:TYPE <value>
<value> ::= {RSTArt | RSTOp | RDATa | RD1 | RD0 | RDX | PARityerror
| TSTArt | TSTOp | TDATa | TD1 | TD0 | TDX}
The :SBUS<n>:UART:TRIGger:TYPE command selects the UART trigger type.
When one of the RD or TD types is selected, the :SBUS<n>:UART:TRIGger:DATA
and :SBUS<n>:UART:TRIGger:QUALifier commands are used to specify the data
value and comparison operator.
The RD1, RD0, RDX, TD1, TD0, and TDX types (for triggering on data and alert bit
values) are only valid when a 9-bit width has been selected.
Query Syntax
:SBUS<n>:UART:TRIGger:TYPE?
The :SBUS<n>:UART:TRIGger:TYPE? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= {RSTA | RSTO | RDAT | RD1 | RD0 | RDX | PAR | TSTA |
TSTO | TDAT | TD1 | TD0 | TDX}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":SBUS<n>:UART:TRIGger:DATA" on page 883
• ":SBUS<n>:UART:TRIGger:QUALifier" on page 885
• ":SBUS<n>:UART:WIDTh" on page 887