Keysight Technologies InfiniiVision 3000T X Series - :COUNter:TOTalize:GATE:POLarity

296 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
11 :COUNter Commands
:COUNter:TOTalize:GATE:POLarity
(see page 1276)
Command Syntax
:COUNter:TOTalize:GATE:POLarity <polarity>
<polarity> ::= {{NEGative | FALLing} | {POSitive | RISing}}
The :COUNter:TOTalize:GATE:POLarity command specifies the gating signal
condition under which totalizer edges are counted.
The gating signal is specified with the :COUNter:TOTalize:GATE:SOURce
command.
Query Syntax
:COUNter:TOTalize:GATE:POLarity?
The :COUNter:TOTalize:GATE:POLarity? query returns the currently specified
gating signal condition.
Return Format
<polarity><NL>
<polarity> ::= {NEG | POS}
See Also • ":COUNter:CURRent" on page 289
• ":COUNter:ENABle" on page 290
• ":COUNter:MODE" on page 291
• ":COUNter:NDIGits" on page 292
• ":COUNter:SOURce" on page 293
• ":COUNter:TOTalize:CLEar" on page 294
• ":COUNter:TOTalize:GATE:ENABle" on page 295
• ":COUNter:TOTalize:GATE:SOURce" on page 297
• ":COUNter:TOTalize:SLOPe" on page 298