EasyManua.ls Logo

Keysight Technologies InfiniiVision 3000T X Series - :POWer:TRANsient:EXIT

Keysight Technologies InfiniiVision 3000T X Series
1420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
652 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:TRANsient:EXIT
(see page 1276)
Command Syntax
:POWer:TRANsient:EXIT
The :POWer:TRANsient:EXIT command exits (stops) the transient analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also ":POWer:TRANsient:APPLy" on page 651
":POWer:TRANsient:IINitial" on page 653
":POWer:TRANsient:INEW" on page 654
":POWer:TRANsient:NEXT" on page 655

Table of Contents

Related product manuals