Keysight Technologies InfiniiVision 3000T X Series - :HARDcopy:FFEed

408 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
19 :HARDcopy Commands
:HARDcopy:FFEed
(see page 1276)
Command Syntax
:HARDcopy:FFEed <ffeed>
<ffeed> ::= {{OFF | 0} | {ON | 1}}
The HARDcopy:FFEed command controls whether a formfeed is output between
the screen image and factors of a hardcopy dump.
Query Syntax
:HARDcopy:FFEed?
The :HARDcopy:FFEed? query returns a flag indicating whether a formfeed is
output at the end of the hardcopy dump.
Return Format
<ffeed><NL>
<ffeed> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 404
• ":HARDcopy:STARt" on page 419
• ":HARDcopy:FACTors" on page 407
• ":HARDcopy:INKSaver" on page 409
• ":HARDcopy:LAYout" on page 410
• ":HARDcopy:PALette" on page 417