Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

Obsolete and Discontinued Commands 37

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1211

:MEASure:UPPer

(see page 1276)

Command Syntax

:MEASure:UPPer <value>

The :MEASure:UPPer command sets the upper measurement threshold value. This

value and the LOWer value represent absolute values when the thresholds are

ABSolute and percentage when the thresholds are PERCent as defined by the

:MEASure:DEFine THResholds command.

Query Syntax

:MEASure:UPPer?

The :MEASure:UPPer? query returns the current upper threshold level.

Return Format

<value> ::= the user-defined upper threshold in NR3 format

See Also • "Introduction to :MEASure Commands" on page 458

• ":MEASure:LOWer" on page 1202

• ":MEASure:THResholds" on page 1205

NOTE

The :MEASure:UPPer command is obsolete and is provided for backward compatibility to

previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see page 467)

instead.

Keysight Technologies InfiniiVision 3000T X Series - :MEASure:UPPer