Keysight Technologies InfiniiVision 3000T X Series User Manual

840 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SENT:TOLerance
(see page 1276)
Command Syntax
:SBUS<n>:SENT:TOLerance <percent>
<percent> ::= from 3-30, in NR1 format.
The :SBUS<n>:SENT:TOLerance command specifies the tolerance for determing
whether the sync pulse is valid. Valid values range from 3% to 30%.
Query Syntax
:SBUS<n>:SENT:TOLerance?
The :SBUS<n>:SENT:TOLerance? query returns the tolerance setting.
Return Format
<percent><NL>
<percent> ::= from 3-30, in NR1 format.
See Also • ":SBUS<n>:SENT:CLOCk" on page 820
• ":SBUS<n>:SENT:CRC" on page 821
• ":SBUS<n>:SENT:DISPlay" on page 822
• ":SBUS<n>:SENT:FORMat" on page 824
• ":SBUS<n>:SENT:IDLE" on page 826
• ":SBUS<n>:SENT:LENGth" on page 827
• ":SBUS<n>:SENT:PPULse" on page 828
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 829
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 830
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 832
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 833
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 834
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 836
• ":SBUS<n>:SENT:SOURce" on page 838
• ":SBUS<n>:SENT:TRIGger" on page 841
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 843
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 844
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 846
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 848
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 849

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English