Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:SOURce:VOLTage

To Next Page

To Previous Page

642 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

26 :POWer Commands

:POWer:SIGNals:SOURce:VOLTage

(see page 1276)

Command Syntax

:POWer:SIGNals:SOURce:VOLTage <source>

::= 1, 2 in NR1 format

<source> ::= CHANnel<n>

<n> ::= 1 to (# analog channels) in NR1 format

The :POWer:SIGNals:SOURce:VOLTage command specifies the first, and

perhaps second, voltage source channel to be used in the power analysis.

Query Syntax

:POWer:SIGNals:SOURce:VOLTage?

The :POWer:SIGNals:SOURce:VOLTage query returns the voltage source

channel setting.

Return Format

<source> ::= CHANnel<n>

<n> ::= 1 to (# analog channels) in NR1 format

See Also • ":POWer:SIGNals:AUTosetup" on page 624

• ":POWer:SIGNals:CYCLes:HARMonics" on page 625

• ":POWer:SIGNals:CYCLes:QUALity" on page 626

• ":POWer:SIGNals:DURation:EFFiciency" on page 627

• ":POWer:SIGNals:DURation:MODulation" on page 628

• ":POWer:SIGNals:DURation:ONOFf:OFF" on page 629

• ":POWer:SIGNals:DURation:ONOFf:ON" on page 630

• ":POWer:SIGNals:DURation:RIPPle" on page 631

• ":POWer:SIGNals:DURation:TRANsient" on page 632

• ":POWer:SIGNals:IEXPected" on page 633

• ":POWer:SIGNals:OVERshoot" on page 634

• ":POWer:SIGNals:VMAXimum:INRush" on page 635

• ":POWer:SIGNals:VMAXimum:ONOFf:OFF" on page 636

• ":POWer:SIGNals:VMAXimum:ONOFf:ON" on page 637

• ":POWer:SIGNals:VSTeady:ONOFf:OFF" on page 638

• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 639

• ":POWer:SIGNals:VSTeady:TRANsient" on page 640

• ":POWer:SIGNals:SOURce:CURRent" on page 641

Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:SOURce:VOLTage<i>