Keysight Technologies InfiniiVision 3000T X Series - :POWer:SWITch:APPLy

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 645
:POWer:SWITch:APPLy
(see page 1276)
Command Syntax
:POWer:SWITch:APPLy
The :POWer:SWITch:APPLy command applies the switching loss analysis using the
conduction calculation method, V reference, and I reference settings.
See Also • ":POWer:SWITch:CONDuction" on page 646
• ":POWer:SWITch:IREFerence" on page 647
• ":POWer:SWITch:RDS" on page 648
• ":POWer:SWITch:VCE" on page 649
• ":POWer:SWITch:VREFerence" on page 650
• ":MEASure:ELOSs" on page 534
• ":MEASure:PLOSs" on page 541