Keysight Technologies InfiniiVision 3000T X Series - :POWer:TRANsient:NEXT

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 655
:POWer:TRANsient:NEXT
(see page 1276)
Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the transient
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 651
• ":POWer:TRANsient:EXIT" on page 652
• ":POWer:TRANsient:IINitial" on page 653
• ":POWer:TRANsient:INEW" on page 654