294 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
11 :COUNter Commands
:COUNter:TOTalize:CLEar
(see page 1276)
Command Syntax
:COUNter:TOTalize:CLEar
The :COUNter:TOTalize:CLEar command zeros the edge event counter.
See Also • ":COUNter:CURRent" on page 289
• ":COUNter:ENABle" on page 290
• ":COUNter:MODE" on page 291
• ":COUNter:NDIGits" on page 292
• ":COUNter:SOURce" on page 293
• ":COUNter:TOTalize:GATE:ENABle" on page 295
• ":COUNter:TOTalize:GATE:POLarity" on page 296
• ":COUNter:TOTalize:GATE:SOURce" on page 297
• ":COUNter:TOTalize:SLOPe" on page 298
To Next Page
Loading...
