Keysight Technologies InfiniiVision 3000T X Series - :SAVE:WMEMory[:STARt]

696 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE:WMEMory[:STARt]
(see page 1276)
Command Syntax
:SAVE:WMEMory[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WMEMory[:STARt] command saves oscilloscope waveform data to a
reference waveform file.
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:WMEMory:SOURce" on page 695
• ":RECall:WMEMory<r>[:STARt]" on page 665
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".h5".